Publicidad
Idiomas disponibles
Idiomas disponibles
To protect the fuel system from gum formation, mix in a
fuel stabilizer when adding fuel. See Storage. All fuel is
not the same. If you experience starting or performance
problems after using fuel, switch to a different fue_
provider or change brands. This engine is certified to
operate on gasoline. The emission control system for
this engine is EM (Engine Modifications).
1.
Clean area around fuel fill cap, remove cap.
2.
Slowly add regular unleaded fuel (A) to fuel
tank (B). Be careful not to overfill. To allow for fuel
expansion, do not fill above the bottom of the fuel
tank neck.
N
_
_g
g
3.
Install fuel cap and wait for any spilled fuel to
evaporate.
CAUTmON! Alcohol-blended
fuels (called gasohol,
ethanol or methanol) can attract moisture, which leads
to separation and formation of acids during storage.
Acidic gas can damage the fuel system of an engine
while in storage.
To avoid engine problems, the fuel system should be
treated with a fuel preserver or emptied before storage
of 30 days or longer. If adding a fuel preserver, fill the
fuel tank with fresh fueL If only partially filled, air in the
tank will promote fue_ deterioration during storage. If
fuel preserver is not used, drain the fuel tank. start the
engine and let it run until the fuel lines and carburetor
are empty. Use fresh fuel next season. See Storage for
additional information.
NEVER use engine or carburetor cleaner products in
the fuel tank as permanent damage may occur.
High A_titude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKI (89 RON) gasoline is acceptable. To
remain emissions compliant, high altitude adjustment is
required. Operation without this adjustment will cause
decreased performance, increased fuel consumption,
and increased emissions. See a qualified Sears dealer
for high altitude adjustment information. Operation of
the engine at altitudes below 2,500 feet (762 meters)
with the high altitude kit is not recommended.
Fresh Start@ Fue_ Cap
The Fresh Start fuel cap (C) is designed to hold a
cartridge (D) which contains fuel preserver. Adding fuel
preserver helps keep fuel fresh and carburetors clean
for easier starting all season long. The Fresh Start fuel
cap, if equipped with a cartridge, automatically drips
concentrated fuel preserver into your fuel tank so you
don't have to add it yourself.
NOTICE
Purchase a Fresh Start fuel preserver
cartridge, Sears item 33386, at your local Sears or by
calling 1-888-331-4589
or online at www.sears.com.
It
is not included with the pressure washer.
Read and follow all instructions and warnings given in
the Fresh Start fuel preserver cartridge package.
Connect
Battery
Cable
Your unit is equipped with electric start capability but
can be started manually. If you choose not to use the
electric start feature, you do not need to connect the
battery cable.
The sealed battery on the pressure washer is pre-
installed except for the two-pin cable.
WARNING
Battery posts, terminals and related
accessories contain lead and lead compounds -
chemicals known to the State of California to cause
cancer and reproductive harm. Wash hands after
handling.
1.
Connect two-pin connectors on top right side of
pressure washer base toward the back (veiwing
2.
Verify that connections to battery and pressure
washer are tight and secure.
NOTICE
If your battery is discharged, charge prior
to use following the instructions in the section Battery
Charger.
Publicidad
