EUROCOM Panther 5SE Guia Del Usuario página 24

Viewing Angles
The emitter's horizontal viewing angle is 100 degrees.
The emitter's vertical viewing angle is 75 degrees.
75
Figure 11 - Emitter - Viewing Angles
Set Up Stereoscopic 3D
After the NVIDIA driver has been installed you can setup
NVIDIA 3D Vision.
1. Click Start, and click Control Panel (or point to Settings and
click Control Panel).
18
2. Double-click NVIDIA Control Panel (click "Classic View" from
the left of the menu if you are in Control Panel Home).
3. Double-click Stereoscopic 3D (if the sub-menus are not
visible), and then click Set up stereoscopic 3D.
4. Click Enable stereoscopic 3D (tickbox) to enable 3D Vision.
5. Click Apply to save the setting.
6. Select the drop-down menu at the bottom of the screen to Test
sterescopic 3D.
7. Select Run Setup Wizard from the drop-down menu (you can
also select Run Medical Image Test from this menu).
8. Follow the on-screen instructions to set up 3D Vision and click
"Next" to progress through the steps (this notebook has a built-
in emitter).
Enable sterescopic 3D
9. During the setup procedure you will need to click to answer
questions on what you see in 3D on the screen.
10. Configure the stereoscopic 3D from the control panels (make
sure you charge the 3D shutter glasses by plugging them into
one of the computer's USB ports using the USB cable
provided).
11. The stereoscopic depth may be adjusted by using the control
panel slider.
Figure 12
Set Up
Stereo-
scopic 3D