AGP QS600 Manual De Instrucciones página 6

WRENCH-STOP LUG
The lug is provided for safely loosening tight bits. The wrench on the
spindle rests against the lug when tapping on the other wrench on
the bit.
CABLE CLIP
A clip is provided for the power supply cable to help keep it away from the bit.
OPTIONAL EXTENSION SPACER
To achieve 600 mm drilling diameter, the extension spacer kit must be used. Place the extension spacer
between the motor mounting plate and the motor and use the long screws in the kit to fasten them together.
OPTIONAL LASER AIMING DEVICE
The laser aiming device allows accurate alignment of two or more holes such as for pipe runs through multiple
walls, etc. Leave the stand fixed in position, unscrew the bit, and thread on the laser aiming device. It will point
at the center of the next hole.
MAINTENANCE
Keep the drill stand clean and routinely inspect for damage and loose fasteners.
ADJUSTING THE DRILL STAND GUIDANCE
Loose guidance will cause the bit to run out-of-true and result in
poor performance and possible damage to the bit. If the rollers can
be turned by hand with the carriage locked, they are too loose.
To adjust the guidance, the two guide rollers on the left side are on
eccentric shafts. Turn the eccentric roller axle bolt until the clearance
is taken up on each roller in turn. Turn just enough so that the roller
cannot be turned by hand. Now test the tightness of the carriage
by cranking it up and down. There should be no backlash, yet no
binding throughout its travel.
GB
(Right side Roller Axle Bolts are not
adjustable)
6
Adjustable Roller
Axle Bolts (left
side only)