Publicidad
Idiomas disponibles
Idiomas disponibles
12. Select an effect "EFFECTS 1"
The EVO4 includes two fully independent effect processors, EFFECTS 1 and EFFECTS 2.
Both work the same way and contain the same number of effects. The processors may be
assigned to the same or different channels. Start out by playing an effect using the
EFFECTS 1 processor, located to the left of channel 1 on the mixer. To assign the
EFFECTS 1 processor to channel 1, turn the INPUT encoder (6) and press it when
CHANNEL 1 appears on the screen. To select an effect, turn the EFFECT encoder (7) and
select the desired effect by pressing the encoder when it appears on the screen.
13. Enable an effect "EFFECTS 1"
Press the LAUNCH button (12) and move the EFFECTS 1 processor DRY/WET crossfader
(11) to fuse the original (DRY) signal with the processed (WET) signal. If you would like to
monitor the effects signal, press FX PFL (10).
14. Adjust an effect "EFFECTS 1"
Move the PARAM 1 (8) and PARAM (9) controllers to adjust the sound of the effect. The
parameters you are adjusting will appear on the screen.
15. Select an effect "EFFECTS 2"
The EFFECTS 2 processor is located to the right of channel 4 on the mixer. To assign the
EFFECTS 2 processor to channel 1, turn the INPUT encoder and press it when CHANNEL
1 appears on the screen. To select an effect, turn the EFFECT encoder and select the
desired effect by pressing the encoder when it appears on the screen.
16. Enable an effect "EFFECTS 2"
Press the LAUNCH button and move the EFFECTS 2 processor DRY/WET crossfader to
fuse the original (DRY) signal with the processed (WET) signal. If you would like to monitor
the effects signal, press FX PFL.
17. Adjust an effect "EFFECTS 2"
Move the PARAM 1 and PARAM 2 controllers to adjust the sound of the effect. The
parameters you are adjusting will appear on the screen.
5
Publicidad
