ISE SY-T2711 Manual Del Usuario página 20

TREADMILL COMMON ERROR MESSAGES
E1: Not connected well between console and electric controller.
Check the condition of cables and ensure that all plugs are connected
Check that the speed sensor and magnet are in correct alignment and that
there are no obstructions on the magnet. (The magnet can be found on
Solution
If the running belt moves then the console displays the E1 error after 10
E2: Abnormal detection of voltage
Make sure the motor cable or electric controller is well connected.
If there is no voltage or abnormal voltage, replace the controller.
Solution
Check if the motor or belt is running properly, or replace the motor.
E3: No speed signal
Ensure that all plugs are connected between the motor controller and
Solution
Check that the speed sensor and magnet are in correct alignment and that
E5: Current exceeds the rated current.
Solution
Check if there is abnormal resistance from running desk, running belt or
between the motor controller and display
the front roller near the motor belt).
seconds, replace the speed sensor.
If the running belt does not move, replace the controller
If the running belt does not move, replace the controller.
there are no obstructions on the magnet.
Loading weight is more than max. loading weight.
motor belt, or spray lubricant oil onto the running desk.
display.
8
EN