ISE SY-T2711 Manual Del Usuario página 21

E6: Less of normal voltage
Solution
E7: Safety key not in the position
Solution
RUNNING BELT ADJUSTMENT METHOD
1. When running belt lean to the left, adjust screw on the left 1-2 turns along the clock-
wise. Then test running, if running belt still lean to the left, repeat the above steps until it
back to the center.
2. When running belt lean to the right, adjust screw on the right 1-2 turns along the
clockwise. Then test running, if running belt still lean to the right, repeat the above steps
until it back to the center.
3. When running belt is too tight, it will cause stronger resistance. Please adjust both
sides screws 1-2 turns along the anticlockwise, loosen the belt until the skidding or paus-
ing is disappeared. 4. When running belt is too loose, please adjust both sides screws 1-2
turns along the clockwise.
Replace the motor cable and display.
Put the safety key in the position.
screw inside
9
screw inside
EN