Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE STARTING ENGINE
WARNING: Be sure to read the fuel
handlinginformation in the safetyrules
sectionof thismanualbefore you begin.
if you do not understandthe fuel ham
dlinginformation do not attemptto fuel
yourunit. Seek help from someonethat
does understand the informationor call
the customerassistance help lineat
1-800-235-5878.
GUIDE BAR AND CHAIN OIL
The chainoiler'providescontinuous lu-
brication to the chain and guidebar. Be
sure to figthe bar oiltank when you fill
the fuel tank (Capacity= 6:8 ft. oz.)
Formaximum guidebar and chainlife,
we recommend you use Craftsman
chainsaw bar oil. If Craftsmanbar oilis
not available, you may use ago0d
grade SAE 30 oil untilyou areable to
obtainCraftsmanbrand. Theo!! output
is automatically metered during opera-
tion. Yoursaw wiUuse approximately
one tankof bar oilfor everytank of fuel
mix. Alwaysfillthe bar oil tankwhen
you fillthe fueltank.
FUELING ENGINE
This engineis certifiedto operateon
unleadedgasoline.Before operation,
gasolinemustbe mixedwith a good
quality 2-cycleair-cooled engine oil. We
recommendCraftsmanbrand oil. Mix
gasoline and oi!at a ratioof 40:1 (A
40:1 ratiois obtainedby mixing3.2
ouncesof oilwith 1 gallon of unleaded
gasoline). DONOTUSEautomotiveoil
or boat oil.These oilswtl_ cause engine
damage.When mixingfuel follow the
instructions printedon the container.
Once oilis added to the gasoline,
shake containermomentarilyto assure
thatthefuel isthoroughlymixed.
Always readand followthe safety rules
relatingtofuel beforefueling yourunit.
IMPORTANT
Experience indicatesthat alcohol
blendedfuels (calledgasoholor using
ethanolor methanol)can attractmois-
ture whichleads to separationand
formation of acids duringstorage;Acid-
ic gascan damagethe fuel systemof
an enginewhilein storage.
To avoidengineproblems,the fuel sys-
tem shouldbe emptiedbefore storage
for 30 days or longer. Drain the gas
tank, startthe engine and let it run until
the fuel linesand carburetorare empty_
Use fresh fuel next season. See STOR,
AGEinstructions for additionalinforma,
tion.•
Nevez' u se engine or carburetorcleaner
productsin the fuel tank or permanent
damage may occur.
See the STORAGE sectionfor additional
information.
STOPPING YOUR ENGINE
• Move On/Stopswitchto the STOP
position.
• Ifengine does not stop, pullchoke
knoboutfully.
STARTING YOUR ENGINE
COLD ENGINE OR WARM ENGINE
AFTER RUNNING OUT OF FUEL
• Fillbar oiltank with bar oil. Yoursaw
willuse approximately one tank of bar
oilfor each tank of fuel mix.
• Prime engine by slowlypressingprim-
er bulb sixtimes.
Primer Bulb
Ignition _"_._//"
V_
STOP--
Turn on ignition by moving On/Stop
switchto ON.
Actuatechokeby pulling choke knob
fullyout. Set saw on the ground.Grip
front handlewith your lefthand and
place rightfoot throughrear handle.
.
ChokePositions
Full
• Set fast idle by depressing the throttle
lockwith your right hand. Then,
squeezethrottletrigger and hold.With
your thumb, press the fast idle lock
down and hold. Next, release the
.
throttle trigger.
• DONOTsqueeze throttle triggerdur-
ing starting; otherwise, it will be nec-
essaryto resetthe fast idle lock.
NOTE: When pullingthe starterrope,
do not use the full extent of the rope.
Do not let starter rope snap back.
Holdhandle.Let rope rewindslowly.
• Pullstarter ropehandle firmly and
quickly with your righthand untilthe
engineattempts to start or 5 pulls.
Thenpush the choke knobfully in.
Publicidad
