Hendi 250167 Manual Del Usuario página 7

Main parts of the product
(Fig.1 on page 3)
1. ON/OFF switch
2. Temperature control
3. Heating indicator
4. Caster without lock (Rear)
5. Caster with lock (Front)
Remark: The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations.
Spare parts or accessories
(Fig.2 on page 3)
6. Rear caster without lock x 2
7. Front caster with lock x 2
8. Screw x 16
9. Spring washer x 16
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Installation or Assembly & Disassembly
(Fig.3 on page 3)
The assembly or disassembly operations of the appliance are
performed with the appliance stopped and disconnected from
the power supply.
1. Two casters with lock should be assembled on front side.
2. Spring washer must be included between the screw and
metal plate of caster.
Operating instructions
• Connect the power plug with a suitable electrical outlet. Make
sure the electrical power supply voltage rating corresponds
with the power supply details shown on the appliance rating
label.
• Turn ON the appliance by pressing the green ON/OFF switch.
• Select the temperature by turning the temperature control
(up to 85ºC) clockwise. Then, orange indicator lights up.
• Once the set temperature is reached, the orange indicato will
go off automatically.
• Now, you are ready to take the warmed plate out.
Note:
- Plate are warm, use the glove if needed (not supplied).
- Turn OFF the appliance by pressing the green ON/OFF switch
before taking out the plate.
After use
• Turn OFF the appliance by pressing the green ON/OFF
switch.
• Unplug the appliance from the electrical outlet.
• Allow the appliance & water to cool down.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Clean the inside of container with a non-abrasive detergent
and rinse with clean water.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for clean-
ing. Do not use petrol or solvents!
• No parts are dishwasher safe.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
• Special care must be taken when moving or transporting the
machine due to its heavy weight. With at least 2 persons or
using a cart. Move the machine slowly, carefully, and never
incline more than 45°.
GB
7