Tognana Iridea Manual De Usuario página 21

OPERATING PRINCIPLE
1. Place the milk frother on a flat and stable surface.
2. Remove it from the base and connect the base itself to the mains.
3. Insert the appropriate accessory for the desired function
in the milk frother, securing it on the special pin.
4. Pour the milk, making sure the volume does not exceed
the MAX sign or is below the MIN sign, and close the lid.
HAZARD: Do not fill the milk frother above the maximum level;
the milk may overflow from the lid and cause burns or injury. Check
that the lid is securely closed before connecting the appliance to the
power.
5. Place the carafe on the power base, which will emit an acoustic signal. The three LEDs will turn
on for 1 second, then turn off again. The milk frother is now in standby mode.
6. The processing time of the appliance varies depending on the selected function.
d) HOT FROTH: in standby mode, press the ON button once, the three function LEDs will turn
on and the "hot froth" function LED (red) will blink. After 2 seconds, the "hot froth" LED
remains steadily lit and the appliance starts working. At the end of processing, the appliance
emits an acoustic signal and the "hot froth" LED turns off; the appliance stops working and
goes back into standby mode. At the end of processing, the milk froth temperature is 60±5°C.
e) HEAT: in standby, press the ON button twice, the three function LEDs will turn on and the
"heat" function LED (green) will blink. After 2 seconds, the "heat" LED remains steadily lit and
the appliance starts working. At the end of processing, the appliance emits an acoustic signal
and the "heat" LED turns off; the appliance stops working and goes back into standby mode.
The milk temperature is now 60±5°C.
f) COLD FROTH: in standby mode, press the ON button three times, the three function LEDs
will turn on and the "cold froth" function LED (blue) will blink. After 2 seconds, the "cold froth"
LED remains steadily lit and the appliance starts working. At the end of processing, the
appliance emits an acoustic signal and the "cold froth" LED turns off; the appliance stops
working and goes back into standby mode. The frothed milk and its temperature are the
same as at the start.
7. To cancel the selected function when the milk frother has already started, press the ON button;
the LED of the selected function will turn off and the milk frother goes back into standby mode.
If necessary, reselect a function and press the ON button again.
8. Disconnect the plug from the power socket, lift the carafe and pour the contents into a suitable
container.
HAZARD:
• Pour the hot milk slowly and take care not to move the milk
frother too suddenly to avoid the risk of splashes.
• Always disconnect the power when the appliance is not being
used.
21