Orbegozo CU 5200 Manual De Instrucciones página 12

CU 5200
BEFORE USING THE APPLIANCE FOR THE FIRST TIME:
Before using the egg cooker for the first time, clean it completely:
• Place the transparent cover, measuring cup and egg tray in water (also adding appropriate cleaner) and
clean them.
• Fill the device with a measuring cup of water, assemble all the parts, but do not put eggs and start the
device, when the water is boiling, stop the process and discard the water.
Note: Never immerse the base in water to clean it. Clean the base and heat plate with a damp cloth and
never use an abrasive cleaner.
UTILIZATION:
1. This egg cooker is suitable for cooking 1 to 7 eggs.
2. Firstly, clean the surface of the heat plate and add 150 ml of water.
3. Pierce the large end of the egg with the measuring cup punch.
4. Then place the eggs into the egg tray, make sure the small end of the egg is facing
down. In this position the egg is more stable. Then put the transparent lid on.
Caution: Eggs must be pierced before boiling, otherwise they may explode during
cooking.
5. Insert the plug into the power outlet and turn the selector so that the pointer points to the desired scale
(soft" ", medium " ", hard"
Note: Do not lift the lid during the cooking process, otherwise the steam needed to cook the eggs would
escape and you could burn yourself.
ATTENTION: the lid has an opening at the top and during cooking hot steam will escape from this opening,
be careful.
6. When cooking is finished, you will hear a "ding" on the timer and the indicator light will turn off.
Caution: After cooking eggs, turn off the power to avoid safety risks.
7. Place the boiled eggs in cold water quickly so they peel easily and reach their maximum flavor
immediately after boiling.
CLEANING AND CARE
- Please observe the safety advices.
- Never us abrasive detergents or sharp utensils.
- Before cleaning, disconnect the plug and let the device cool down completely.
- Remove the lid and then the egg tray from motor base. Clean both parts together with the measuring
cup with water.
- Make sure none of the electric parts of the device will be in contact with water during the cleaning
process.
- Store the device in its original packaging or at a dry, clean place.
SPECIFICATIONS
Power supply: 230V~50Hz.
Power: 400W.
") and the indicator on the switch lights up.
12