Geemarc CL7400 Manual De Uso página 18

English
Troubleshooting:
• NO SOUND
1. Ensure that the mains adapter is pushed fully into the power outlet and that
its cable is properly connected to the DC IN 6V connector on the transmitter.
2. Ensure that the headphones On/Off switch is switched to the On Position
and the switch is illuminant Green.
3. The headphones battery charge level may be too low. please replace the
headset back on it's cradle to recharge the batteries until the green light is
illuminated on the left hand headset.
4. Ensure that your DVD, TV set, Hi-Fi system or audio component is switched
on and set to a channel that broadcasts an audio signal.
5. Use the headphones volume control to increase the sound level (only when
use as a wireless headphone).
6. The audio signal input level is too low. Increase the volume from the audio
source of Hi-Fi, CD, or TV, etc.
7. The connected audio/video equipment may not be in playback mode. Start
playback on by the equipment.
8. The headphones output level is set too low. Adjust the volume to a suitable
level.
• DISTORTION
9. Restart the Pairing process. Press the "Pair" button 3sec on the transmitter
and the headphone. The process is finished when both LEDs are in Green.
10.The headphone's batteries charge level may be too low. Recharge the
batteries.
11.Ensure that the volume setting is correct.
12.The headphones may be too far away from the transmitter. Move closer to it.
13.The audio signal input level is too strong. decrease the volume from the
audio source of Hi-Fi, CD, or TV, etc.
NOTE: In the event of the television not having the standard red and
white audio output RCA, or the audio jack, then most likely the TV will have an
optical audio output. By purchasing a Geemarc optical converter (our reference
CL7XX_OPT) this will allow the CL7400 to connect to the TV's optical output
successfully.
17