Publicidad
Idiomas disponibles
Idiomas disponibles
Before connecting the product, ensure that the mains voltage indicated on the rating plate
•
matches that of your mains power supply.
Do not connect the product to an external timer, an external control system or to an
•
extension cord.
Check both power cord and plug regularly for signs of damage or wear, and if there is
•
any, do not use the product and have the power cord and/or plug replaced or repaired by
authorized service personnel.
If the power fails during use, immediately turn off the product and unplug the power cord.
•
Do not pull on the cord to unplug the product.
•
Do not move the product by pulling the cord or twist the cord.
•
Be careful not to trip over the cable and make sure the cable is not kinked, twisted, or stuck.
•
Do not place the cable on hot surfaces or near oil.
•
Do not leave the cable hanging over the edge of a table or countertop.
•
3. INSTRUCTIONS FOR USE
3.1 Assembly
1.
Place the product upside down
on a soft cotton cloth or carpet.
2.
Align the holes in the bottom of the
product with the holes in the legs.
3.
Insert the screws through the holes.
4.
Tighten them with a screwdriver.
3.2 Operation
Caution: the product gets hot! Do not touch the hot surfaces.
1.
The product beeps when it is turned on. The product starts in antifreeze mode (standby)
and displays the current temperature of the room.
2.
Press the power button to turn on the product.
3.
On first use, see the status light "heating" and the symbol "ECO mode" turn on. This means
that the product is in ECO mode.
English
21
Publicidad
