inda AV154A Manual Del Usuario página 21

B
G
D
Howto install this unit without plug-connected wire:
1 Loosen the screw which on the bottom of the dryer holder, disassemble the
front cover
2 Pull the reserved wire through the hole show in fig. 2
(there are three holes are available for the direct wiring).
3 Fix the reserved wire on terminal,please notice its direction of N, L wire replace
terminal to its ori
4 Fix the bracket to the wall then fix the front cover to the bracket screwing the
screw on the bottom to make the bracket and front cover tightly
5 Turn on general power and move power switch to "ON" position.
How to use:
"1" for hot heating, "2" for warm heating "c" for cool shot.
A
F
E
Fig. 1
F
C
21
Fig. 2
Fig. 3