Publicidad
Idiomas disponibles
Idiomas disponibles
• When using the hairdryer, always make sure that grid X (fig.1) is not
obstructed. Lack of air suction will overheat the appliance, temporarily disabling it.
• Do not use hair-spray while the appliance is switched on.
Installation:
The wall holder may be installed in one of two ways:
A = for fixed connection lead
B = for mobile connection lead
Attention: before installing the wall holder always switch off the ge-
neral switch of your mains electricity.
Each time the appliance is opened, the switch must be used to disconnect the
appliance. The cable to connect to the power supply must be type H05VV-F
2
2x1,5 mm
.
Use and product care:
Support switch 5 (Fig.1).
Hairdryer switch 7 (Fig.1):
ON=On/Off (pressure must be maintained to operate the hairdryer)
Slide Switch 3 (Fig.1):
Cool = (low power)
1 = (medium power)
2 = (maximum power)
• When not in use, the mains switch on the wall holder 5 (Fig.1)
should be in the "Off" position.
• The hairdryer requires no special care or attention.
• You can clean your appliance with a cloth dampened with water.
Attention: The cleaning of hairdryers with detergents, solvents, alcohol and
other chemical products is strictly prohibited. When necessary, the air inlet grill
should be cleaned with a soft brush or by vacuum cleaner.
• If the hair-dryer overheats because of incorrect use or it is defective,
it will stop automatically. In this case switch the support switch 5 (Fig.1) to position
0, let go of the hair-dryer switch 5 and remove the external cause of overheating.
After the appliance has cooled down for a few minutes it will be ready for use
again.
5
Publicidad
