Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION OF THE SOLAR STRING LIGHTS
The solar string lights have a variety of possible
ways to be mounted. The following are examples
of the most common ways:
(1) Temporary mounting: Using standard S hooks
(not included) or screw hooks (not included) the
solar string lights can be mounted utilizing the
integrated mounting loops.
(2) Permanent mounting: Using cable tie wraps
or 'zip ties' (not included) or using nails or
screws into a surface, the solar string lights can
be mounted more permanently.
(3) Guide wire installation: Using S hooks
(not included) attach the string lights to a
pre-installed guide wire (not included).
(4) Structural installation: To create a draping
effect for the solar string lights attach the first
bulb to a structure, then only mount every 3-4th
bulb to create the desired effect. Complete the
effect by mounting the last bulb to a structure.
Note: The solar string lights will illuminate for
4-5 hours depending on the charge level of the
batteries.
(5) The final step of installation is to connect
the solar panel to the string lights. Simply insert
the plug located after the final bulb into the wire
coming from the solar panel. Tighten the plug
by screwing the seal over the connection point.
OPERATION:
After the initial three day charge, the solar string
lights are ready to use.
When ON is selected, the bulbs will illuminate when
the solar panel is in darkness. When not required, it
is advisable to keep the ON/OFF switch in the OFF
position as this will help
battery maintenance.
BATTERY REPLACEMENT
The solar string light's batteries (I) are installed on
the rear of the solar panel. Always open the battery
compartment with the ON/OFF switch in the OFF
position.
Unscrew the back of the battery compartment and
remove the backing piece. Inside you will see the
batteries.
When replacing the batteries, observe the correct
polarity and match the battery specifications with
the batteries you have removed.
Use rechargeable batteries only.
Replace the back of the battery compartment and
continue to use the solar string lights as required.
IMPORTANT NOTE
Remember, when the string lights are
connected and the switch is in the
ON position, the string lights will only
illuminate in the dark. Whenever the solar
panel receives sunlight, the bulbs will not
illuminate-this is normal and correct.
HOW TO REPLACE THE BULB?
Step 1:
Step 2:
Carefully unscrew the
Completely remove the
light bulb.
light bulb.
Only use 3V, 0.3W LED bulbs. For more information on replacement bulbs, contact Sunforce Products Inc.
at info@sunforceproducts.com or call 1-888-478-6435.
8
Step 3:
Step 4:
Carefully screw in the
Once the bulb is
replacement bulb.
securely screwed into
place you are ready to use
as required.
Publicidad
