Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING
WARNING: Check to see that all connections
are tight, including ground, and that no bare wire is
visible at the wire nuts, except for the ground wire.
CAUTION: Do not use with a wall light dimmer
switch.
NOTE: The fan must be installed at a maximum
distance of 20 ft. from the remote control for proper
signal transmission between the remote control and
the fan's receiving unit.
If you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan to your
household wiring. Use the plastic wire nuts (AA &
BB) with your fan. Secure the plastic wire nuts
with electrical tape. Make sure there are no loose
strands or connections.
1. Make wire connections from the fan to the
receiver as follows, using the wire nuts (BB).
From fan
Blue Wire -------------- Blue Wire "For Light"
Black Wire ------------- Black Wire "To Motor L"
White Wire ------------- White Wire "To Motor N"
2. Make wire connections from the receiver to the
outlet box as follows, using the wire nuts (AA).
From receiver
Black wire "AC in L"------ Black wire (hot)
White wire "AC in N"----- White wire (neutral)
From fan
Green wire*----------------- Green or bare wire
* There are two green grounding leads:
one from the mounting plate (A) and one
from the fan motor assembly (E).
Turn the wire nut connections upward,
spreading them apart so the green
(ground) and white wires will be on one
side and the black and blue wires will be
on the other side.
To receiver
To outlet box
To outlet box
(ground)
Hardware Used
Wire Nut
Wire Nut
1
Hot
Black
Receiver
9
x 3
x 3
Neutral
Ground
White
Conductor
Outlet Box
Publicidad
