Publicidad
Idiomas disponibles
Idiomas disponibles
Recording
Before proceeding
e Turn on the power of all components.
¢ When connecting components for tape dubbing:
e 'fusing a DAT deck for recording, set it for analog recording.
The TAPE 1 and 2 terminals are for connection of the source
deck or recording deck.
The TAPE 3 terminals are for connection of the recording
deck only.
STEREOINTEGRATED AMPLFER AM-00
| Select the recording source with the REC OUT SELEC-
9
Pi
z
TOR switch as follows:
Wi folariceladtare Migt-me-rere)celiale|
For auxiliary source recording:
Select LINE
For digital source recording (AM-69 model oniy):
Select DIGITAL 1/2/3 and then press the DIGITAL SELEC-
TOR 1, 2o0r3 button depending on which digital terminal the
source component is connected to.
For tape dubbing:
Select TAPE COPY 1 -— 2/3 when recording from a cas-
sette deck or DAT deck connected to the TAPE 1 terminals.
For tape dubbing:
Listening to another source during -
ixcterelael tale)
If you wish to listen to another source during recording, simply
select that source with the input selector buttons. Recording will
not be interrupted.
To adjust the sound of the selected source (using the VOLUME,
Select
TAPE COPY 2 -> 1/3 when recording from a cas-
BALANCE, BASS, TREBLE, MODE or MUTING controis), set
sette deck or DAT deck connected to the TAPE 2 terminals.
the SOURCE DIRECT switch to OFF (SUBSONIC) before rec-
.
ording. Signals being recorded will not be affected by adjust-
2 After adjusting the recording level of the cassette deck
ments.
or DAT deck, start recording.
Note:
After recording is finished:
© During recording do not change the position of the REC OUT
Set the REC OUT SELECTOR switch to OFF and turn off the
SELECTOR switch as this will interfere with recording.
power.
e For AM-69 model: During digital source recording, do not
change the DIGITAL 1, 2 or 3 input selector button setting as
this will interfere with recording.
11
Publicidad
