Descargar Imprimir esta página

Jatrhg LZ-32-P Manual Del Usuario página 7

Estación de carga para ve

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

4.3 Current setting
The supported range for user-defined current settings is: 13A/16A/24A/32A/AU.
The symbol 【32】 represents the maximum of 32A, while "AU" stands for automatic.
Upon each system startup, the default current mode is set to automatic.
Press the button, and a red arrow will appear in front of "Set curr" (continuing to press
the button allows for cycling through "Set Current", "Schedu-T", and "Time" settings).
Clique button:
B
To set the current, long-press for 3 seconds when the red arrow points
to "Set curr" to enter the current setting mode.
Press the button to switch between different current options.
long-press for 3 seconds to confirm your selection.
4.4 Scheduled time setting
The Scheduled time setting can be used to set delayed charging. You can select the time
for the delay, and the system will automatically initiate the charging function after the
set time.
B
Press the button, and a red arrow will appear in front of "Set curr".
Continue pressing the button, and a red arrow will appear in front of
"Schedu-T".
Long press the button for 3 seconds to enter the "Schedu-T" setting mode.
Pressing the button once increases the time by 30 minutes, up to a
maximum of 24 hours.
Long press the button for 3 seconds to confirm.
Long-press 3s button:
B
B
B
EN
Two ways to cancel the scheduled mode:
4.5 Timer setting
Timer-based charging is used to limit the duration of charging starting from this
moment. Once set, charging begins, and the Timer enters a countdown. Charging will
B
B
pause when the Timer reaches 0 or when the battery is fully charged.
Press the button, and a red arrow will appear in front of "Set curr".
Continue pressing the button, and a red arrow will appear in front of "Timer".
Long press the button for 3 seconds to enter the "Timer" setting mode.
Pressing the button once increases the time by 30 minutes, up to a maximum of 12
hours.
Long press the button for 3 seconds to confirm.
4.6 Charging
To start the charging process, connect the charging
cable to the electric vehicle and ensure it is locked. The
JATRHG charging station begins communicating with the
car via the type 2 connector.
Stalling the vehicle , open the AC charging port of the car.
Increase the scheduled time until it exceeds 24 hours, at which
point it will reset to 0 hours, effectively canceling the
appointment.
Disconnect the power and restart.
B
Power on the JATRHG charging station.
EN
B

Publicidad

loading

Este manual también es adecuado para:

Lb-16-3pLb-32-3p