Publicidad
Idiomas disponibles
Idiomas disponibles
- After each use, wipe all surfaces with a clean,
dry cloth.
MAINTENANCE AND CLEANING
- Clean and wipe the exterior of the appliance
and all accessories removing all remaining
water with a drop cloth.
- Regularly check for obvious defects suhch as
loose fixings and worn or damaged compo-
nents.
- Empty the detergent tank and clean it with
If any anomaly is detected, check the following table.
No detergent suction
Pump does not reach the
necessary pressure
Fluctuating pressure
Motor suddenly stops
Detergent applicator is clogged
Water inlet filter is clogged
Pump is sucking air from hose
connections
Nozzle is worn or not correct
Unloader is clogged or worn
Valves are clogged or worn
Pump is sucking air from hose
connections
Clogged nozzle
Valves are dirty, worn or stuck
Water seals worn
Extension cord is too long or
wire size too small
Thermal safety switch has
tripped
current water, so all the remaining detergent is
wiped out.
STORAGE
- Dismount the unit following the steps on moun-
ting but afterwards.
- Ensure cables are not trapped when stroing.
Clean applicator with warm water. If
it not works, replace the applicator
Clean water inlet filter
Check that connections and locking
ring are properly tightened
Bring the appliance to any customer
service
Check that connections and locking
ring are properly tightened
Clean the nozzle with the typ
cleaner.
Bring the appliance to any customer
service
Remove extension cord
Check the voltage in the main
supply match the voltage indicated
on the Rating Label
Publicidad
