Publicidad
Idiomas disponibles
Idiomas disponibles
putting it back in the appliance. You can also replace them if necessary. Avoid direct sunlight or intense
overheating. Never put the filters in the washing appliance to prevent deformation. Do not use abrasive
or cleaning products and wash from the bottom of the filter.
1
PLEASE NOTE
·
Make sure that all components are correctly assembled before using the vacuum cleaner again.
·
Always use the vacuum cleaner with the filters intact. If you do not do this, you may lose suction force
or damage the motor.
·
Unplug the plug before cleaning the filters.
·
Do not put the filter into the dishwasher.
·
Do not use a hairdryer to dry the filters.
PROBLEM AND SOLUTION
Problem
The appliance
does not start.
The suction is
too weak.
There is a
burning smell
from the
appliance.
38
DO7297S
Cause
The appliance is not
plugged in.
The appliance is not turned on.
The appliance is not correctly
assembled, so the suction is
being lost.
The dust reservoir is full.
The hose is clogged.
The filters are dirty.
The air regulator is open.
The filters are congested.
The appliance is overheated.
2
Solution
Put the plug in the socket.
Press the on/off switch.
Check that everything is assembled correctly.
Remove all of the accessories and then replace
them step by step in their place.
Empty the dust reservoir and make sure that it
does not exceed the maximum level.
Insert the hose in the reverse manner (with the
handle) in the suction opening of the appliance.
The clog will be suctioned to the other side,
which will free the hose.
Carefully clean the filters as described in this
manual. It is very important that you already
thoroughly clean the filters.
Close the air regulator.
Over time, the pores in the filters will become
congested. Replace the filters.
Immediately switch off the appliance and let the
appliance cool down. Clean the dust reservoir and
the filters.
Publicidad
