Publicidad
Idiomas disponibles
Idiomas disponibles
Ifyou need a ssistance,
contact your
Failure tofollow a ll S afety Rules and
Sears Service Center orcall
Precautions
can result inserious injury.
1-800-235-5878.
SAVE THESE INSTRUCTIONS
• To reduce the risk of electrical
shock,
this unit has a polarized
plug (one
blade is wider than the other) and will
require the use of a polarized
exten-
sion cord. The appliance
plug will fit
into a polarized
extension
cord only
one way.
If the plug does not fit fully
into the extension
cord, reverse the
plug.
Ifthe plug still does not fit, ob-
tain a correct polarized
extension
cord.
A polarized
extension
cord will
require the use of a polarized
wall
outlet. This plug will fit into the polar-
ized wall outlet only one way. If plug
does not fit fully into the wall outlet,
reverse the plug. If it still does not fit,
contact
a qualified electrician
to
install the proper wall outlet. Do not
change the equipment
plug, exten-
sion cord receptacle,
or extension
cord plug in any way.
CARTON CONTENTS
Model 358.748200
• Blower
• Blower Tube
Examine parts for damage.
Do not use
damaged
parts.
NOTE: If you need assistance
or find
parts missing or damaged,
call
1-800-235-5878.
,_
WARNING:
If received assembled,
ensure your unit is properly assembled
and all fasteners are secure.
ATTACHING
THE BLOWER
TUBE
1. Align the grooves on the blower tube
with the grooves on the blower outlet.
2. Push the blower tube onto the blower
outlet until it snaps into place (tube is
secured by red tube release button).
3. To removethe
blowertube,
pressthe
tube release button while pulling on
tube.
Blower outlet
Blower Tube
SELECT AN EXTENSION
CORD
Use only a 120 A.C. voltage
supply as
shown on nameplate
of the unit to
power your blower.
The extension
cord used to reach the
power source must be:
• Specifically marked as suitable for out-
door use. The cord must be marked
with the suffix 'M/'.
• Heavy enough to carry full current
from the power source to the unit.
Otherwise,
loss of power and over-
heating can occur causing damage
to unit. Refer to table for minimum
wire gauge recommendations.
The
cord must be marked with the proper
wire gauge. (Appropriate
extension
cords are available.)
Do not use mul-
tiple cords.
In good condition. Cord insulation
must be intact with no cracks or
deterioration.
Plug connectors
must be
undamaged.
DO NOT use multiple
cords.
MINIMUM
WIRE
GAUGE
RECOMMENDATIONS
VOLTS
25 FT.
50 FT.
100 FT.
18
16
14
120
A.W.G.*
A.W.G.*
A.W.G.*
*American
Wire
Gauge
Secure the extension cord to the unit by
threading the cord through the cord re-
tainer (see illustration). Insert the cord
receptacle into the recessed plug.
CAUTION:
Failure to use cord retain-
er could result in damage to the unit,
extension
cord, or both.
Cord
Receptacle
Cord
Recessed
Plug
on Unit
Publicidad
