Mannesmann 81145 Instrucciones De Servicio página 5

Application
• Place the base plate with 360° pitch (8)
on a flat surface, or screw it onto the
stand (5).
• Place the self-levelling cross laser onto
the base plate (8).
• Adjust the base plate by rotating the
adjusting feet (9) until the marking of the
point spirit level on the laser housing (3)
is in the centre of the spirit level.
• If you use a stand, the spirit level (6) is
used for the adjustment of the stand.
Adjust the feet of the stand until the
marking is positioned within the circle.
• Rotate the switch (4) to activate the
cross laser. Rotating the switch also
releases the transportation lock.
• In case of deviations of more than 3° ,
both laser beams will flash after the
activation of the cross laser. Deactivate
the cross laser and adjust the base plate
and the stand until both laser beams
constantly light up.
• Rotate the switch (4) to activate the
cross laser. A horizontal and a vertical
line are projected onto the target surface
forming an angle of 90° .
• Apply markings according to the projec-
ted lines or adjust the object to the laser
lines.
• If required, the housing can be rotated
on the base plate in any angle around its
vertical axis.
Laser adjustment (fig. 4)
The laser is automatically adjusted within a
range of +/- 3 ° after a period of approx. 7
seconds.
Two years of warranty
The warranty period for this device begins
with the date of purchase. You can prove
the date of purchase by sending us the
original sales slip.
We grant the following services during the
warranty period:
• remedy of possible malfunctions free of
charge
• free replacement of damaged parts
• including free specialist service (i.e. free
assembly carried out by our specialists)
A prerequisite, however, is that the
malfunction has not been caused by
incorrect handling.
In case of queries or quality problems,
please directly contact the manufacturer:
Brüder Mannesmann Werkzeuge GmbH
Abt. Reparatur-Service
Lempstraße 24
D-42859 Remscheid / Germany
Telephone: +49 2191/37 14 71
Facsimile: +49 2191/38 64 77
Old power tools and environmental
protection
• If one day your measuring device is too
old to be used anymore and it has to be
replaced, or if you do not use the device
anymore, you are obliged to dispose of
the device in your local recycling point.
• For information on the location of such
recycling points, please refer to your
local disposal companies and/or your
local authorities.
• The crossed-out dustbin is a symbol for
your obligation to return the device
to a collection point for power tools
in order to be recycled.