Publicidad
Idiomas disponibles
Idiomas disponibles
DH-40
| Shower aid
DH-40 L
6. Check before use
Before use, ensure that all screws are tight and that the chair is
standing on a level surface.
After adjusting the height of the shower aid, it is particularly
important to ensure that the spring pins are correctly engaged
The rubber feet are a wearing part and must not be damaged. If
they are damaged, they can be replaced by your specialist dealer
if necessary.
6.1. Using the shower aid
Place the shower aid in the shower. Make sure that all four
rubber feet are securely on the floor or shower tray. People who are
unsure about using the shower should only enter it with the help of a
carer.
Use the shower aid like a normal aid.
Do not lean backwards or too far to the side, otherwise there is a risk
of tipping over.
The upholstery material is made of water-repellent plastic.
Use the handles to sit down and stand up.
You can attach the shower head to the front of the seat (right and
10.
left) during personal hygiene (Fig. 10).
38
Caution! The press studs must visibly engage in the
holes.
Important! The handles and backrest can only
be fitted by persons with sufficient strength due
to the high operating forces.
Now you can get on with your personal hygiene. Excess water drains
away quickly through the holes in the seat.
Remove any soap residue after use and dry the shower aid.
Caution! Shower aids are generally less
resistant to tipping than chairs in the home.
Therefore, avoid leaning out to the side.
Lifting points
You can lift the shower aid by the metal frame to carry it over
obstacles or steps. Avoid lifting the aid by the seat.
Beware of the risk of slipping! There is a risk of
slipping when sitting down or standing up in wet
rooms, especially if there is soap on the floor.
Bischoff & Bischoff GmbH | 05-12-2023 - Revision: 2
DH-40
Shower aid |
DH-40 L
39
Publicidad
