Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMED
EDIT RECORDING
Programmed edit function enables CD recording while checking
the remaining time on each side of the tape as the tracks are
programmed.
m
The programmed edit recording will not start from a point halfway
in the tape, The tape must be recorded from the beginning of
either side.
1
2
3
4
5
Insert the tape into deck 2, and press the DOLBY
NR button to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press
the CD button
and
load the disc(s).
Press the CD EDIT/CHECK
button twice.
"EDIT" and "PRGM" light up on the display.
mm
Press the +
or
b button to designate the tape
length.
10 to
99
minutes can be specified.
Maximum recording
Tape length
time for side A
I
Tape side A (front side)
Press the DISC DIRECT PLAY button, then press
one of the numbered
buttons
1 to 3 within 3
seconds on the remote control.
Then, press the numbered buttons and the + 10
button on the remote control to program a track.
Example: To select the 10th track of disc 2, press the DISC
DIRECT PLAY and 2 buttons, then press the + 10 and O
buttons.
6
'7
8
Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Remaining time
of side A
1
Total number
Programmed
of programmed
tracks
tracks
Press the CD EDIT/CHECK
button to select side
B and program the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B (reverse side)
Press the O REC/REC
MUTE button to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side (A) ends, recording
on the back side (B) starts.
To stop recording
Press the
button. Recording and CD play stop simultaneously.
To check the order of the programmed
track numbers
Before recording, press the CD EDIT/CHECK button to select
side A or B, and press the 4
or -
button repeatedly.
Program number
Track number
Programmed
track numbers
To change the program of each side
Press the CD EDIT/CHECK button to select side A or B, and
press the
CLEAR button to clear the program of the selected
side. Then program tracks again.
To clear the edit program
Press the
button twice so that "EDIT
disappears on the
display.
Recording is inhibited if the erasure prevention tab on either side
of the tape is broken off.
ENGLISH
18
Publicidad
