Publicidad
Idiomas disponibles
Idiomas disponibles
CHARACTERISTICS
ES
▶Power: 55W
▶Speeds: 3 levels
▶Fixed or oscillating position
PT
▶Safety grille
▶Blade diameter: 40cm
▶Control with LED screen or remote control
EN
▶Maximum air flow 300m3/h
▶220-240V~ 50Hz
INSTALLATION
FR
1. Open the box and carefully remove the main body, the
grille and the fan blades. For proper storage in the future, be
sure to keep the box in good condition.
2. Remove the Fan Blades:
• Unscrew the blade from the locknut.
• The locknut will remain on the back cover.
• Remove the locknut from the back of the rear cover.
3. Install the Head:
• Turn the fan blade nut clockwise and the grill nut
counterclockwise.
• Fit the rear grille onto the motor shaft and secure it with the grille
nut.
• Fit the fan blades onto the engine shaft and secure with the fan
blade nut.
• Remove the front grille, place it next to the rear grille and then
secure it with a screw.
4. Wall mounting:
• Attach the iron plate to the wall using two nails and two plastic
screws (see picture below).
• Connect the fan body to the iron plate mounted on the wall.
Instruction manual
INSTRUCTIONS FOR USE
Before using the fan, it is important to ensure that it is installed
correctly on the wall. Follow these steps for proper operation:
Note: After turning it on, you will hear a "Pii" tone, the power
indicator will light red and the machine will enter standby status.
At this time, only the "Power/ON" key will be valid.
1. In the standby state, press the ON button on the fan control
panel (the LED display) or the ON/OFF button on the remote
control. The fan will then be ready to select the functions you
want. The three indicators for timing, oscillation and speed
will illuminate.
2. Press the Speed key to switch between high, medium
or low speed options. The digital display will show the
corresponding F1, F2 and F3.
3. Pressing the Rotate key will start the fan to move the head
from left to right in an oscillating manner and pressing it
again will stop the oscillating function.
4. Use the Timer button to set the time of use.
5. After 2 minutes of no activity, the brightness of the fan's
LED display will be reduced to 30%. Any key pressed in this
state will activate the corresponding function with a dim
Tapa trasera del motor
Cubierta
Eje motor
• Each time you press the timer button, it will increase by 1 hour: 1
→ 2 → 3 ... up to 15H in one cycle.
• The set value will be confirmed automatically after 3 seconds
without pressing any other key.
• At the same time, the "h" icon on the digital display of the fan
will light up and the timing indicator light will follow the change
during the countdown.
Ref. 33527
Agujero central
Tuerca de la rejilla
Parte interna rejilla
Aspas del ventilador
Tuerca para fijar
las aspas
Publicidad
