GE 20 Manual Del Propietario E Instalación página 13

Installation Instructions
[] CONNECT THE TUBING TO THE
REFRIGERATOR (CONT.)
S()me models have the refl'igerator connection at
the end of robing located outside the compressor
comi)arm_ent access cover. On other models, the
COU/l)ressor COUll)_lI'tIIlent access cover UltlSt be
removed in order to access the refrigerator
connection at the water wflve.
On models using tile refrigeration connection at
the water xalxe, remoxe the plastic flexible cap.
©
Place tile compression nut and ti_Hule (sleeve)
onto the end of the tubing as shown. On a GE
SulartConnect'l RefiJgerator Tubing kit, the ntltS
are ah'eadv assembled to the tubing.
Insert tile end of tile tubing into tile refl'igerator
connection as flu" as possible. While holding the
robing, tighten tile fitting.
For plastic tubing from a GE Smart(:onnec("
Refrigerator Tubing kit, insert tile molded end of
tile tubing into tile reti'igerator connection and
tighten the compression nut tmtil it is hand tight,
then tighten one additional turn with a wrench.
Overtightening may cause leaks.
Fasten the robing into the clamp provided as
shown to kee I) it in position. You may need to pry
open tile clamp.
One of the illustrations below will look like the
commction on your refrigerator.
Tubing
Clamp _
1/4"
Compression
Nut _
1/4"
Tubing
Ferrule
(sleeve)
SleartConnect TM
Connection Tubing
[] CONNECT THE TUBING TO THE
REFRIGERATOR (CONT.)
Tubing 1/4" 1/4"
Tubing
Ferrule
(sleeve)
Connection
SmartConnecff M
Tubing
I_TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten am connections that leak.
Reattach tile access cover.
[] PLUG IN THE REFRIGERATOR
__rraw,e tile coil of tubing so that it does not vii)rate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
[] START THE ICEMAKER
Set tile icemaker power switch to tile
I (on)
position.
Tile icemaker will not begin to operate until it
reaches its operating temperature of I5°F
(-9°(:)
or below. It will then begin operation automatically
if the icemaker power switch is in the I (0n) positiol_.
J_
NOTE: In lower water pressm'e conditions, tile
water xalxe ulav turn on t/I ) to 3 times to delixer
enow,h water to tile icemaker.
13