Milwaukee 7,5 m LED Tape Measure Manual Original página 11

TECHNICAL DATA
Type
Tape length
Tape width
Dimensions
Rated power output
Battery voltage
USB input
Charging time
Luminous flux
Mode high
Mode low
Lighting time
Colour rendering index (CRI)
Colour temperature
Protection class
Electrical protection class
Weight according EPTA-Procedure 01/2014
Recommended ambient operating temperature
Recommended ambient charging temperature
WARNING!
Read all safety warnings and all
instructions. Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS BATTERY-LAMP
Warning: Do not direct the light beam at persons or animals
and do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious injury
or vision loss.
The light source of this luminaire is not replaceable; when the
light source reaches its end of life the whole luminaire shall be
replaced.
This appliance contains batteries that are non-replaceable.
SAFETY INSTRUCTIONS BATTERY
Battery acid may leak from damaged batteries under extreme
load or extreme temperatures. In case of contact with battery
acid wash it off immediately with soap and water. In case of eye
contact rinse thoroughly for at least 10 minutes and immediately
seek medical attention.
Warning! To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach containing products,
etc., can cause a short circuit.
ADDITIONAL SAFETY INSTRUCTIONS
Be careful not to injure yourself when rolling up the tape
measure, as it rewinds very quickly. Hold the tape measure firmly
and let it rewind slowly. If necessary, use the finger stop braking
function.
SPECIFIED CONDITIONS OF USE
The LED tape measure is suitable for measuring lengths of up
to 7.5 m. The reading area can be illuminated with the integrated
light.
Do not use this product in any other way as stated for normal
use.
20
LED TAPE MEASURE
Tape measure
7,5 m
30 mm
100 x 80 x 55 mm
1 W
4 V
5 V 0,1 A - 2,1 A
2,5 h
100 lm
50 lm
2,5 h
≥ 80
4000 K
IP54
III
0,5 kg
-20 °C ... +40 °C
+5 °C ... +40 °C
CHARGING
Plug your USB cable into a power source such as an AC wall
adaptor, computer or car port.
The indicator light will display the charging status:
Red breathing: charging 0-49% charged
Yellow breathing: charging, 50-99% charged
Green solid: 100% charged
Red solid: over temperature (too hot)
Red/Green flashing: cold or faulty
If the light continues to flash red and green, the battery may be
cold, faulty, or the battery did not fully charge after 5 hours. If the
light is solid red, the battery is too hot. Allow the battery to cool
down. Turn the light on or plug in for charging.
FUEL GAUGE
Press the switch 3 times to check the fuel gauge:
Red flashing: < 3% remaining
Red solid: 3-9% remaining
Yellow solid: 10-49% remaining
Green solid: 50-100% remaining
NOTES FOR LI-ION BATTERIES
Use of Li-Ion batteries
Batteries which have not been used for some time should be
recharged before use.
Temperatures in excess of 50°C (122°F) reduce the performance
of the battery. Avoid extended exposure to heat or sunshine (risk
of overheating).
The contacts of chargers and batteries must be kept clean.
For an optimum life-time, the batteries have to be fully charged,
after used.
To obtain the longest possible battery life remove the battery
pack from the charger once it is fully charged.
For battery storage longer than 30 days:
Store the battery where the temperature is below 27°C and away
from moisture
Store the battery in a 30% - 50% charged condition
Every six months of storage, charge the battery as normal.
Transport of Li-Ion batteries
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance
ENGLISH
with local, national and international provisions and regulations.
• The user can transport the batteries by road without further
requirements.
• Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation
and transport are exclusively to be carried out by appropriately
trained persons and the process has to be accompanied by
corresponding experts.
When transporting batteries:
• Ensure that battery contact terminals are protected and
insulated to prevent short circuit.
• Ensure that battery pack is secured against movement within
packaging.
• Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
MAINTENANCE
Use only Milwaukee accessories and Milwaukee spare parts.
Should components need to be replaced which have not been
described, please contact one of our Milwaukee service agents
(see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the machine type printed as well as the six-digit No. on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before starting
the machine.
CAUTION! WARNING! DANGER!)
Do not stare at the operating light source
USB Port
Class III electrical protection.
Always wear goggles
Not insulated, do not use on or near live circuits.
Do not dispose of waste batteries, waste electrical
and electronic equipment as unsorted municipal
waste. Waste batteries and waste electrical and
electronic equipment must be collected separately.
Waste batteries, waste accumulators and light
sources have to be removed from equipment.
Check with your local authority or retailer for
recycling advice and collection point.
According to local regulations retailers may have an
obligation to take back waste batteries and Waste
electrical and electronic equipment free of charge.
Your contribution to re-use and recycling of waste
batteries and waste electrical and electronic
equipment helps to reduce the demand of raw
materials.
Waste batteries, in particular containing lithium and
waste Electrical and electronic equipment contain
valuable, recyclable materials, which can adversely
impact the environment and the human health, if
not disposed of in an environmentally compatible
manner.
Delete personal data from waste equipment, if any.
Direct current
Protection class
IP54
European Conformity Mark
UK Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
ENGLISH 21