Craftsman 917.370890 Manual Del Usuario página 8

The operation of any lawn
SAFETY GLASSES mower can result in foreign
objectsthrowninto the eyes,
whichcanresultinsevereeye
damage.Alwayswearsafety
glasses or eye shieldswhile operatingyour
lawn mower or performingany adjustments
or repairs.Werecommenda standardsafety
glasses or wide vision safety mask worn
over spectacles.
HOW TO USE
YOUR MOWER
ENGINE SPEED
Engine speed was set at the factory for
optimum performance. It is not adjustable.
DRIVE CONTROL ADJUSTMENT
Over time, the drive control system may
become "loose", resulting in decreased
speed. There is a turnbuckle on the drive
control housing to increase tension on the
drive cable. Proceed as follows:
1. Turn unit off and disconnect spark plug
wire from spark plug.
2. Rotate turnbuckle on drive control to
increase drive speed.
3. Operate mower to test drive speed.
Readjust as required.
4. If condition fails to improve after the
above steps (forward speed remains
the same), your drive belt is worn and
should be replaced.
ENGINE ZONE CONTROL
AI:_CAUTION: Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under
any circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
DRIVE CONTROL
• Self-propelling is controlled by holding
the operator presence control bar down
to the handle and pulling either drive
control lever rearward to the handle.
The further toward the handle a lever is
pulled, the faster the unit will travel.
• Forward motion will stop when either
the operator presence control bar or a
drive control lever are released. To stop
forward motion without stopping engine,
release a drive control lever only. Hold
operator presence control bar down
against handle to continue mowing with-
out self-propelling.
NOTE: If after releasing the drive control
the mower will not roll backwards, push
the mower forward slightly to disengage
drive wheels.
Operator presence control bar
rive
control levers
Adjustment
turnbuckle
TO ADJUST CUTTING HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements. Medium position is
best for most lawns.
• To change cutting height, squeeze ad-
juster lever toward wheel. Move wheel
up or down to suit your requirements.
Be sure all wheels are in the same set-
ting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
ROTATE LEVER TOWARD
ENGINE TO LOWER MOWER
Plate tab
ROTATE LEVER AWAY FROM ENGINE
TO RAISE MOWER
-Lever
TO ENGAGE DRIVE CONTROL
DRIVE CONTROL DISENGAGED 8