Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
INSTALLATION
1. Flush all water lines until water is clear before connecting faucet
to supply stops.
2. Make sure the tee shaped fitting with filter is installed on the
control module.
3. Avoid surroundings with bright lights, highly reflective surfaces
and sunlight which can affect the sensor's performance.
MOUNTING STEPS
Step 1
Step 3
Step 4
Step 5
Step 7
1. Insert sensor cable and inlet shank through the
base gasket and sink opening.
2. Secure using mounting washer and nut provided.
3. Connect 1/4" NPSM end of hose to inlet shank.
4. Connect 1/2" NPSM end of hose
to control module.
5. Position the white arrow on the sensor cable
towards the front of the control module box.
6. Screw the knurled nut on the sensor cable onto
the control module connector.
7. Connect the mixing valve to the tee-shaped
fitting with filter.
2
Publicidad
