camry Premium CR 7822 Manual De Uso página 8

close to hot surfaces. Do not place the heater under an electrical outlet.
15. The surface of the heater can heat up to high temperatures of over 60 degrees C. Take
care when near the heater.
16. When using the heater, completely unwind its cable and make sure that the cable is not
touching the hot surface of the heater.
17. The device must be completely cool prior to storage. Keep the original packaging to
store the heater in during non-heating seasons.
18. If disposing of the heater please follow rules of ethylene disposal.
19. Use the device assembled and mounted to the wall.
WARNING: Do not use this heater in small rooms where there are people who are unable
to leave them by themselves, unless constant supervision is ensured.
DESCRIPTION OF DEVICE: Heater - look at Figure 10
A. Heating rack for towel
Control panel (B) description – look at Figure 8
1.Power button ON / OFF
3.Timer button
5. Plus button
LED display (2) description – look at Figure 8
AREA I: status indication:
- The Sun icon – power on icon
- "R" letter icon – room temperature fixing mode
- "T" letter icon – towel rack heating mode
AREA II: temperature fixing indication:
- "SET" – indicates that you are in process to setting up: required temperature in room, or the rack temperature, or the
heating time.
- "ON" – indicates the device is switched on.
- "OFF" – indicates the device is switched off and enters stand-by mode
AREA III: time indication – it starts to operate after press the timer button (3)
- "TIME" – indicates that you are in process to setting up time in 24-hours format.
OPERATION
1.To switch on the device press the power button ON /OFF (1). To switch off the device press the power button ON /OFF (1) again, then
the OFF inscription remains lighted up to communicate the device is on standby mode.
2. Mode setting
Press the mode button (6) to choose between the room temperature mode (R letter) and the towel rack mode (T letter), corresponding
icon will be lighted up. Then, set up:
2A. TOWEL RACK TEMPERATURE SETTING (T):
If chosen T – the LED display (2) shows the temperature of the towel rack surface:
Press the button plus (5) or the button minus (4) to set the temperature of rack in the range: 40-70 degree of Celsius. The display will
flash and exit after 5 seconds.
After 2 minutes of display (2) inactivity, there will be displayed only "ON" and "T" towel rack mode icons, it enters a semi lit state.
2B. ROOM TEMPERATURE SETTING (R):
If chosen R - the LED display (2) shows present room temperature.
Press the button plus (5) or the button minus (4) to set desired temperature in room in the range: 0-37 degree of Celsius. The display will
flash and exit after 5 seconds.
3. Time setting
To activate the timer, press the timer button (3) on the control panel (B). The timer indication will appear on the display in area III. Press the
button plus (5) or the button minus (4) to set the countdown time between 1 hour and 24 hours. The display shows the time in descending
B. Control panel
2.LED display
4. Minus button
6. Mode choice button "MOD"
8