Publicidad
Idiomas disponibles
Idiomas disponibles
memorise the new position.
• The new position will be memorised in the selected button.
● Adjusting height and tilt adjust the height of the bed, and the
motors inside each column will move at the same time.
- Use the buttons
and
1
height and/or tilt of the bed, and the motors inside each
column will move independently.
● Adjusting backrest tilt
EN
4
to activate the control knob. The
red indicator will light up and all its
functions can be
again and the red indicator will turn
off at the same time as the bed
remains flat and in the lowest
position possible.
-
Press the buttons P1, P2, P3
to place the bed in one of the 3
factory-stored positions.
-
Set any of the 3 factory-
stored positions to a new position:
•
Once the bed is in the
desired position, press the SET
button until the blue indicator lights
up.
•
While the blue indicator is
lit, press one of the three buttons
(P1, P2, P3) for where you want to
of the hand controller to adjust the
2
-
Use the buttons adjust the tilt of the backrest.
● Adjusting footrest tilt
-
Use the buttons adjust the tilt of the footrest.
Manual functions
● Adjusting the armrest
- To lower the armrests, move the lever operating the gas
piston and press down on the armrest to the desired position.
When you release the lever, the armrest will stay in its
current position.
- To raise the armrests, move the lever operating the gas piston
while pressing lightly on the armrest, preventing it from rising
too fast.
EN
3
Publicidad
