Descargar Imprimir esta página

Snapper 030215 Manual Del Propietário página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

SNAPPER
WARNING
WHEN
ADJUSTING
OR NAKING
REPAIRSTOYOUR
GENERATOR
" Disconnect
the spark plug wire from the spark plug and place
the wire where it cannot contact
spark plug.
WHEN
TESTING
FOR ENGINE
SPARK
. Use approved spark plug tester.
. DO NOT check for spark with spark plug removed.
WARNING
. DO NOT touch
hot surfaces.
. Allow equipment
to cool before touching.
. The generator
must be at least 5 feet from structures
having
combustible
walls and/or other combustible
materials.
. Keep at least 3 feet of clearance on all sides of generator
for
adequate cooling, maintenance
and servicing.
. In the State of California
a spark arrester
is required
by law
(Section 4442 of the California
Public Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands. If you equip the muffler with a spark arrester, it must be
maintained
in effective working
order.
DO NOT tamper with governed
speed. Generator
supplies
correct
rated frequency
and voltage when running at governed
speed.
DO NOT modify generator
in any way.
CAUTION
See "Don't
Overload
Generator".
Start generator
and let engine stabilize before connecting
electrical
loads.
Connect
electrical
loads in OFF position, then turn ON for
operation.
Turn electrical
loads OFF and disconnect
from generator
before stopping generator.
CAUTION
Use generator
only for intended uses.
If you have questions about intended use, as[< dealer or call
1-800-317-7833.
Operate
generator
only on level surfaces.
DO NOT expose generator
to excessive moisture, dust, dirt,
or
corrosive
vapors.
DO NOT insert any objects through cooling
slots.
If connected
devices overheat, turn them off and disconnect
them from generator.
Shut off generator
if."
-electrical
output
is lost;
-equipment
sparks, smokes, or emits flames;
-unit vibrates
excessively.

Publicidad

loading