Publicidad
Idiomas disponibles
Idiomas disponibles
.
5.
NOTE:
Be sure to install both wheels with the air
pressure valve on the outboard
side.
Place the e-ring onto the groove in the axle.You may
add the flat washer if desired.
Place one end of the needle nose pliers on the bottom
of the axle and the other end of the pliers on top of
the e=ring. Seat the e=ring by pressing the pliers closed.
6.
Repeat step 3 through 5 to secure second wheel.
7.
Remove the temporary
blocks.
8.
Attach the vibration
mounts to the support leg with
I/4-20 x I" capscrews and I/4-20 lock nuts.
9.
To aid support leg assembly, rest generator
on cradle,
engine end down. Remove the existing hardware from
the left unit vibration
mount with 13mm wrench. Use
the same hardware to attach the support leg.
I 0. Attach the other side of the support leg with a M8 x
20 mm capscrew and M8 lock nut. Rest generator
on
wheels and support
leg.
I I. Center the handle bracket on generator
frame at
support leg end of cradle, as shown.
12. Attach handle bracket with two M8 x 45mm cap
screws and two locking hex nuts.
13. Check that all fasteners
are tight and the tires are inflated
to the value marked on the tire or within
I5 and 40 psi.
BEFORE
STARTING
THE
ENGINE
Add Engine Oil
• Place generator
on a level surface.
CAUTION
. Refer to engine manual
for oil fill information.
. Damage
to equipment
resulting
from failure to follow this
instruction
will void warranty.
Refer to engine owner's
manual and follow oil
recommendations
and instructions.
NOTE:
Check
oil often
during engine break-in.
Refer to
engine owner's
manual for recommendations.
NOTE:
The generator
assembly
rotates
on a prelubricated
and sealed ball bearing that requires
no additional
lubrication
for the life of the bearing.
Add Fuel
NOTE:
This gasoline engine is certified to operate on
gasoline. Exhaust Emission Control
System: EM (Engine
Modifications).
|WARNING
WHEN
ADDING
FUEL
. Turn generator
OFF and let it cool at least 2 minutes before
removing fuel cap. Loosen cap slowly to relieve pressure in
tank.
. Fill fuel tank outdoors.
. DO NOT overfill tank.Allow space for fuel expansion.
. Keep fuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
. DO NOT light a cigarette or smoke.
Use clean, fresh, regular UNLEADED
fuel with a
minimum
of 85 octane.
DO NOT use fuel which
contains
Methanol.
DO NOT
mix oil with fuel.
2.
Clean area around fuel fill cap, remove cap.
3.
Slowly add regular unleaded fuel to fuel tank. Be careful
not to overfill.Allow
about 1.5" of tank space for fuel
expansion (Figure 2).
C
_!
ir'_'_-J!l
iNilll
lll!,
_NNNNNNNNNN_'..-JNNN_
Jilli_-_._,Jilit_.--Jilllli,
4.
Install fuel cap and wipe up any spilled fuel.
Publicidad
