Husky CWR48B Guía De Uso Y Cuidado página 4

Assembly Instructions
Step 4
Install Cross Beam (B) into the assembled welded brackets by inserting the inside tabs located on the ends of the
cross beams into the two mid-center slots on both welded brackets (see figure 6). Use a rubber maller to tap down
on both ends of the cross beam to properly seat the tabs into the narrow ends of the slots (see figure 7).
Figure 7
Figure 6
B
Next bolt the cross beam into the welded brackets on each side by using one Slotted Hex Bolt (G) and one Lock
Nut (I) through the holes located on the side ends of the cross beam and the welded brackets. These holes should
already be lined up (see Figure 8).
Figure 8
✓
Tool(s):
Flat-head
Screwdriver
4