Publicidad
Idiomas disponibles
Idiomas disponibles
During Assembly
Make sure
the
base
is
square by measuring
the diagonals and
level by using
a
spirit
level.
You
may
use
silicone lubricant spray
in
order to help you
slide
the panels into the profiles.
Do
not spray the polycarbonate
panels.
Use
a
rubber mallet if
necessary.
When
encountering the information
icon, please refer to the relevant
assembly step for additional comments and
assistance.
This icon
indicates
that the installer should
be
inside the product.
Attention
This
icon indicates
that
the installer should
be
outside the product.
During assembly
use
a
soft surface below the parts to avoid scratches and damages.
Steps
Step
5
:
If
trays
are
dropping down when filled with
soil,
push
trays'frame
up
and
tight
these screws again on
their original position.
Step 26+27
:
make
sure
profiles
are
inserted
all
the way till the end into plastic connector.
Steps
29:
If
lid does
not located correctly
on
the frame it will not closed and opened properly.
Try
re-checking Step
22 (measure) and Step
26+27 (insert profiles
all
the
way).
For
easy
inserting
of
profile
960 use
lubricant material or move
lid up and
down.
Do
not
use
hammer.
* Please
tighten
all screws
when completing assembly.
Screws
411
and nuts 412 are used
thruoghout
the assembly
process.
Screws
411
are
to
be
assembled from the outside and nuts 412 from the inside of the
greenhouse.
Do
not fasten
screws
and nuts
(411 &
412)
more than
23-
turns only.
Do
not tighten
them until completion of the
panels' assembly,
if not specified otherwise.
However,
in
some
steps,
temporary tightening of
a
few
screws may
be
needed to
prevent
a
profile from falling.
Note:
Firmly connect the product to
a
leve surface
immediately after completion of the
assembly.
Anchoring this product to the ground
is
essential to
its
stability
and rigidity.
It
is
required
to complete this
stage
in
order for your warranty to
be
valid.
Publicidad
