Publicidad
Idiomas disponibles
Idiomas disponibles
Carbon heater Use instructions
INSTRUCTIONS FOR USE
Base assembly
Assemble the carbon heater body and the base,
using the specific fixing screws (fig.5).
OPERATION
WARNING! DO NOT COVER THE HEATER DURING
OPERATION
Place the heater on a horizontal surface.
Press the "HALF HEAT" button in order to turn on only one heating element (MINIMUM HEAT)
Press the "FULL HEAT" button in order to even turn on the second heating element (MAXIMUM
HEAT)
Press the "SWING" button in order to turn on and turn off the swing function of the heater.
SECURITY DEVICES
1. The heater is provided with an automatic tip-over off switch, capable of turning off the heater in
case of accidental overturning.
2. Protection from the overheating capable of suspending the electricity supply of the product in
case of excessive heating.
CLEANING AND MAINTENANCE
Before every cleaning operation, unplug the power adaptor of the electrical outlet.
Clean the carbon heater body with a barely damp soft fabric.
Do not use chemical products for cleaning (thinners, scraping products etc.).
Do not place the heater, if it's still hot, in its original box.
Contact the technical assistance in case of doubt and/or for any question about cleaning and main-
tenance.
TECHNICAL DATA:
Power: 1200W
Power supply: 220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment. The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose of the appliance, it must be separa-
tely collected.
9
Publicidad
