jcm-tech 230START Manual Del Usuario página 4

Groups
Receivers can be configured with a group (from 0 to 7) so that there is no interference when working near each other.
Group configuration
The configuration can be carried out with the programming tool or by self-programming as follows.
Self-programming: After the receiver has been totally reset, it will be configured with the group of the first radio-programmed
transmitter by enabling the hands free mode.
Exception: If the receiver has been configured using programming tools, the group may only be changed with the pro-
gramming tool.
Operations: On powering the receiver, the led will flash the same number of times as the group number with which it is con-
figured.
C = channel
G = group
Group 0 enables all groups.
jcmtechnologies
4