HQ-Power HQRL30001R Manual Del Usuario página 5

4. Shaping the LED light rope
1. Switch off the mains power before you continue.
2. The length of the LED light rope assembly is 30 m.
Exceeding the maximum length may cause overheating and fire.
3. The bending radius of the LED light rope is at least 30 cm, do not make sharp
bends.
Bending radius r = min. 30 cm
4. Bend the LED light rope according to the pictures on page 2.
5. Installing
1. When you have shaped the LED light rope, test it again as described above.
2. If the shaped LED light rope works correctly, you can proceed with mounting. Keep
the light plugged in to warm up the plastic. This makes it more pliable when
installing.
3. Switch off the mains power before you actually install the LED light rope.
6. Use
Check the LED light rope before every use. Always refer to the safety instructions
above.
7. Technical Specifications
power supply
LEDs/m
LED space
IP index
diameter
power cord length
Power consumption
Number of LEDs
Length LED rope
colour of LEDs
Colour temperature
LED life span
Colour rendering index
Luminous flux
Beam angle
Use this device with original accessories only. Velleman Group nv cannot be held responsible
in the event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to change without prior notice.
V. 01 – 09/04/2024
HQRL30001R
5
220-240 V~, 50/60 Hz
36
2.78 cm
IP44
Ø 13 mm
1.5 m
75 W
1080
30 meter
Cold white
6500 °K
20000 h
82
2850 lm
360°
©Velleman Group nv