Publicidad
Idiomas disponibles
Idiomas disponibles
Trickle Charging Function
Trickle/float charge function is specially designed to keep charging and maintain batteries
for a long time, perfect for idle car or boat batteries, etc.
NC202 battery charger will auto-enter trickle charging mode after fully charged also
auto-detect the battery voltage, and re-start the charging process if the voltage drops
below 12.5 volts.
Maintain/Repair
NOTE: Not all batteries can be repaired to 100%, you can purchase a battery tester
to know it's health status.
1. Connect the battery with AC plug and switch to repair mode, the screen displays "PUL".
2. Usually car batteries requires about 4 hours under repair mode, and 2 hours for the
motorcycle batteries and wet batteries. (You could keep the battery in repair mode if the
battery is not overheated until the proper Status of Health index is reached).
3. It has current input into the battery during the repair mode and will charge the battery
after a long time repair process.
4. If you need to stop the repair process in advance, just remove the charger's clips and
disconnect the power.
CAUTION: STOP repair mode immediately If the battery has serious heating or burning
smell! (The main reason is due to the battery internal was vulcanized and lack of water,
please replace battery asap）
TEMP Compensation
1. Winter (
):0-10℃ Summer (
Normal Temperature: 10-27℃ (no icon displayed)
2. During the charging process, the charger will automatically detect the environment
and working temperature， automatically adjust the best charging status to protect
the battery life and ensure safe charging.
3. Detect the temperature and adjust every 3-5 seconds, there will be a very slight
deviation but won't affect the entire charging process.
): >28℃
EN - 5
Publicidad
