EN
Operating Command
Switch on it, and make it vertical upward for 5 seconds
(as shown in the picture)
Playback and Download
Once the Wi-Fi is connected, enter the App' s gallery for playback and download.
Indicator light
Lights
Indicator - yellow light
Fill light - green light
Description
Enable or disable the Wi-Fi
Description
Power on and in standby mode: steady on;
During recording: flash slowly at 5Hz;
When the battery level is below 20%: flash fast at 20Hz;
When Wi-Fi is enabled: light dimly;
If the above states exist at the same time, the corresponding
states are displayed cyclically;
When charging: one indicator lights dimly;
When fully charged: the above indicator lights brightly;
When the ambient light is low: two fill lights turn on
automatically;
When the ambient light returns to normal: the two fill lights
automatically turn off;
III. Operating Instruction for
Different Fishing Methods
Connection and Operation
In all fishing methods, it is recommended to use a rig that is lighter and thinner than the main
line, so that your camera can be kept on the main fishing line to the greatest extent possible in
case the lure gets stuck or the rig breaks.
Conventional casting rod
Attach the camera to the fishing line as shown.
Guide line
After the camera is connected, the rod can be cast normally, but it should be noted that the
casting distance may be longer after the weight is increased.
When casting, you are recommended to adopt side cast rather than overhead cast.
Trolling
Attach the camera to the fishing line as shown.
Counterweight
After the camera is connected, you can troll normally. If you troll faster, it is recommended to
add a counterweight on the main line (as shown in the figure) to ensure that the camera will
not float up when the speed is high. The counterweight can be adjusted according to your
preset trolling speed.
Guide line
EN