Publicidad
Idiomas disponibles
Idiomas disponibles
EN
24
Multi outlet connection
If you want to realize a multi-way supply system, refer to the method shown in
blow illustration for connection of the pipelines.
triple-joint
hot water
outlet
water pool
1.
First, open any one of the outlet valves at the outlet of the water heater, then,
open the inlet valve. The water heater gets filled with water. When water flows
out of the outlet pipe it implies that the geyser has been filled fully with water,
and the outlet valve can be closed.
Note: During normal operation, the inlet valve shall be always kept open.
2.
Insert the supply plug into the supply socket, and switch ON.
3.
Adjust the temperature controller suitably. The HEATING indicator will light
up.
4.
The temperature controller will automatically control the temperature. When
the temperature inside the heater has reached the set temperature, it will
switch off automatically, when the water temperature falls below the set point
the heater will be turned on automatically to restore the heating. When the
heater is switched off automatically, the heating indicator will switch off.
Caution: The multifunction valve attached with the heater must be installed at
the cold water inlet of this heater (See Fig. 5).
cold water
outlet
mixing valve
Fig. 4
power supply cord
heater
multifunction valve
water inlet valve
shower nozzle
running water pipe
Publicidad
