Behringer SPRING REVERBERATION 646 Manual De Instrucciones página 10

Idiomas disponibles

SPRING REVERBERATION 646

(EN)

Eurorack Installation

The Spring Type 646 can be taken out of its factory chassis and fitted into a standard Eurorack case (not supplied).

We recommend that this procedure is carried out only by an experienced service technician to prevent personal injury or damage to

the Spring Type 646. The Eurorack case will need to have a suitable power supply with enough capacity to power the Spring Type 646.

Consumption is 1 amp at 12 V DC.

A 10 pin to 16 pin adapter ribbon cable is supplied with the Spring Type 646.

Please ensure that the Eurorack case will supply ±12 V DC and ground to the correct pins, and that the cable is at the correct orientation

before proceeding.

Procedure

Please follow all steps in the correct order.

1. Disconnect the power and all other connections to the Spring Type 646.

2. Undo the eight screws on the top panel as shown. There is no need to undo any other screw.

3. Carefully lift the top panel assembly, and turn it over so that the PCB is facing upwards. Be careful not to pull the ribbon cable from

the lower side of the main PCB.

4. Disconnect the 24 pin ribbon cable from the main PCB of the Spring Type 646 and remove the assembly from the chassis.

Disconnect from

Main PCB

5. Store the chassis assembly and power supply in a safe, dry place.

6. Securely connect the 10 pin end of the supplied ribbon cable adapter to the main PCB of the Spring Type 646.

7. Having ensured that your Eurorack case is isolated from the mains connect the 16 pin end of the ribbon cable to a spare outlet

in the case.

8. Secure the Spring Type 646 to the case using the eight panel screws.

9. Perform a full safety test before using the Spring Type 646.

SPRING REVERBERATION 646 Getting started

Step 3: Getting Started

(EN)

OVERVIEW

This 'getting started' guide will help you set up your Spring Type 646 and briefly introduce its capabilities.

CONNECTION

To connect the Spring Type 646 to your system, please consult the connection guide earlier in this document.

HARDWARE SETUP

Make all the connections in your system. Keep the Spring Type 646 power turned off when making any connections.

Ensure your sound system is turned down.

Turn on the Spring Type 646 before turning on any power amplifiers and turn it off last. This will help prevent any turn on or turn off "pops

or thumps" in your speakers.

WARM UP TIME

We recommend leaving 15 minutes or more time for the Spring Type 646 to warm up before recording or live performance. (Longer if it

has been brought in from the cold). This will allow the precision analog circuits time to reach their normal operating temperature and

tuned performance.

Quick Start Guide