Publicidad
Idiomas disponibles
Idiomas disponibles
English
Recommended battery
specifications:
Two 12 V,
135AH/C20
maintenance-free batteries.
The maximum volume of the
battery: 13.1 in X 6.90 in X 8.43 in
1. Park the machine on a level
ground, turn off all power switches
and take out the key.
2.Raise the recovery tank so
that the battery compartment can
be reached. (As shown below).
3. Carefully install the battery
in the battery compartment, and
arrange the battery terminals as
shown in the figure below (Figure 2)
4. Connect the battery wiring to
the battery terminal, as shown in
the figure (as shown below)
Connect red to positive (+) and
black to negative (-).
10
How the Machine Works
Cleaning Method:
Water and detergent flow to the
brush plate and the ground through
the water valve and solenoid valve.
Use detergent and water to clean
the floor by rotating the brush
plate. When the machine is moving
forward, the generated sewage
is sucked into the recovery tank
through the squeegee assembly
and the suction motor.
Brush and Scouring Pad
Information
To ensure the best results,
please use the appropriate type of
brush when cleaning.
The brushes and scouring pads
recommended for T260 are as
follows:
Brush plate: 500mm 19.5"
Malish scrubbing brush
Polishing pad (white)-used
to maintain a highly smooth or
polished floor, and drain the
water first, then clean it to prevent
scratching the floor.
Cushion pad (red)-used to
scrub light dirt without hurting the
ground.
Scrub pad (blue)-used to scrub
moderate to heavy dirt. Wipe away
dirt, stains and wear marks, and
make the floor surface clean for
recoating.
Sanding pad (brown)-used to
remove the coating on the floor
surface for recoating.
Gravity sanding pad (black)-
used for strong removal of heavy
coatings or substrates, or for super-
strong scrubbing.
Tennant T260 (10- 2023)
Publicidad
