Publicidad
Idiomas disponibles
Idiomas disponibles
CHANGE VELCRO DISC HOLDER
Locking pin
The locking bore is attainable by the oval
opening (fig.1) in the aluminum sleeve,
Choose the locking pin, contained in the
delivery.
Turn carefully the velcro disc holder by hand
until the drive shaft locking bore (fig.2) is
visible and accessible for the locking pin.
Push the locking pin into the locking bore
(fig.2). Caution: The locking pin must be
inserted through the first visible bore in an
underlying bore. Sometimes, the two bores are
not one above the other, rotate the velcro disc
holder carefully again, until the two bores are
one above the other.
If the drive shaft is locked, the velcro disc
holder can now be loosened by turning
counterclockwise by hand.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
fig.1
fig.2
Publicidad
