Ryobi PBLSV747 Manual Del Operador página 8

WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
WARNING:
NEVER IMMERSE OR EXPOSE YOUR BATTERY PACK
TO CORROSIVE OR CONDUCTIVE FLUIDS OR ALLOW
THESE FLUIDS TO FLOW INSIDE THE BATTERY PACK.
CAUTION:
To Reduce The Risk Of Injury From Moving Parts –
Remove Battery Before Servicing.
CAUTION:
Risk Of Injury. Brush May Start Unexpectedly. Remove
Battery Before Cleaning or Servicing.
CLEANING AND STORAGE
„ Empty and clean the clean tank and dirty tank with warm
water and mild soap. Allow to completely dry before
storage.
„ The dirty tank should be disinfected as needed and before
prolonged storage.
„ Store indoors in a place that is inaccessible to children.
Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
MAINTENANCE
NOTE: ILLUSTRATIONS START ON PAGE 9
CLEANING THE FILTER
See Figure 12, page 11.
„ Remove the battery pack.
„ Push dirty tank release button to remove tank from front
of vacuum.
„ Lift filter tab to remove filter from filter unit housing.
„ Lightly shake any dust or dirt off the filter.
„ Wash with clean, fresh water.
„ Place filter in filter slot of self-cleaning stand to dry.
NOTE: Allow 24 hours for parts to dry completely.
To replace:
„ Replace dry filter back into the filter unit housing.
NOTE: Make sure the filter is seated properly.
When purchasing a replacement filter, request recommended
A32SV747F.
USING THE SELF-CLEANING FEATURE
See Figure 13, page 11.
„ Place vacuum into the self-cleaning stand as shown.
NOTE: The electrical connection in the self-cleaning
stand must fit into the port on the bottom of the vacuum.
„ Push the self-clean pedal with your foot to begin vacuum
self-cleaning feature.
NOTE: The roller will spin for 60 seconds in the tray before
coming to a stop.
REMOVING THE ROLLER
See Figure 14, page 11.
„ Remove the battery pack.
„ Squeeze roller housing buttons together to remove cover
of roller housing.
„ Pull roller lever up and remove roller from vacuum.
„ Rinse roller bar if needed.
„ Place roller bar in roller bar slot of self-cleaning stand
to dry.
NOTE: Allow 24 hours for parts to dry completely.
To replace:
„ Place roller bar onto roller cogwheel.
„ Lower roller lever to lock roller onto vacuum.
„ Snap roller bar housing cover back into place.
8 — English