MDI-2M
10 XLR OUTPUTS
Connect a mixer, studio monitor or PA system to these outputs using an XLR-M/F cable
wired as follows:
PIN 1 - Ground (earth),
PIN 2 - Positive (+ or hot),
PIN 3 - Negative (- or cold).
11 PAD
Pressing this switch reduces the output level by -30dB. Use the PAD in situations where
there is a very high input signal that is close to distorting.
12 GROUND
Pressing this switch lifts pin-1 on both XLR-M outputs.
Use this function to earth hums and loops.
INSTALLATION ADVICE
Before making any connections, check that the Output Level and Headphones Level knobs
are set to -∞. Then connect the power supply, input source and outputs and adjust the
listening volume level as required.
The digital input Audio In does not require any additional dedicated drivers. To connect the
unit to your computer/mobile device, follow the instructions given the chapter Connections.
14
CONNECTIONS
C
/
CHARGER
(max 5A)
/
C
C
C
/
CHARGER
(max 5A)
User manual
PC/MAC
/
C
A
ANDROID
A
C
For some devices it may be necessary
to activate the OTG function from the dedicated OS menu.
15