Publicidad
Idiomas disponibles
Idiomas disponibles
LY
Read these instructions and this manual in its entirety
before you attempt to assemble or operate your' new lawn
mower.. Your new lawn mower has been assembled at the
factory with the exception of those parts left unassembled
for shipping purposes., To ensure safe and proper opera-
tion of your lawn mower; all parts and hardware you
assemble must be tightened securely.
Use the correct
tools as necessary to ensure proper tightness_ All parts
such as nuts, washers, bolts, etc,, necessary to complete
the assembly have been placed in the parts bag.
TO REMOVE LAWN MOWER FROM
CARTON
o
Remove loose parts included with mower,_
•
Cut down two end corners of carton and lay end
panel down fiat.
o
Remove all packing materials except padding be-
tween upper and lower handle and padding holding
operator presence control bar to upper handle.
.
Roll lawn mower out o[ carton and check carton
thoroughly for additional loose parts.
HOW TO SET UP YOUR LAWN
MOWER
TO UNFOLD HANDLE (See Figs. 1 & 2)
IMPORTANT:
UNFOLD HANDLE CAREFULLY SO AS
NOT TO PfNCH OR DAMAGE CONTROL CABLES,.
•
Raise lower handle section to operating position and
align hole in handle with one of three height positioning
holes.
°
Insert handle bolt through handle and bracket and
secure with knob°
•
Repeat for opposite side of handle,
°
Raise upper handle section to operating position, re-
move protective padding and tighten handle knobs
securely_
•
Remove any packing material from around control bar,.
•
Your handles may be adjusted for your mowing com-
fort, Refer to Service and Adjustments section of this
manual
OPERATOR PRESENCE
CONTROL BAR
UPPER HANDLE
LIFT UP
MOWING POSITION
LOWER HANDLE
FIG. 1
HANDLE
ADJUSTMENT
BRACKET
J
FIG. 2
Publicidad
