MESTIC Power Station MPS-1800 Instrucciones De Uso página 24

Car charging
The power station can be charged using a car charging port. It should be charged after the car starts to avoid car
battery loss and failure to start. At the same time, ensure a good connection between the car charging port and
the cigarette lighter. We take no responsibility for any loss caused by improper operation.
Intelligent inversion
To avoid operation faults arising from charging overload, when the total output power exceeds the rated output
power, the constant output power will be automatically enabled, allowing the power station to supply power to
high-power devices at the rated output power.
Please take note of the following while using constant power:
1. The constant power output function is not enabled by default and can be turned on or off via the app.
2. The constant power output function is not enabled in the following cases:
•
When AC output is turned on during charging (bypass mode).
•
When constant power output is turned off.
3. The constant power output function is more suitable for heaters and motors instead of all electrical
equipment. It is not suitable for some electrical appliances with voltage protection (such as precision
instruments). The application of the constant power output function is subject to actual testing.
APP
You can control and view information and data about this product through the app. For detailed usage
instructions, please refer to the WiFi Connection Instructions:
EPS Function
This product supports the EPS (emergency backup power) function. Connect the power grid to the AC input
port of this product using the AC charging cable; it operates in Bypass mode (AC power comes from the grid,
not the battery). In the event of a sudden power loss from the grid, the product can automatically switch to
battery power supply mode within 14 milliseconds. At this time, it functions in inverter mode. Please note that
this function does not support 0 milliseconds switching. Avoid connecting it to devices that require high
uninterrupted power supply, such as data servers and workstations, unless compatibility is confirmed through
multiple tests. It is recommended to use only one device at a time to avoid overload protection. If the device
does not operate normally or data is lost due to failure to follow instructions, we will not be responsible.