Descargar Imprimir esta página

AENO VS2 Guia De Inicio Rapido página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 119
ENG
The AENO vacuum sealer is designed for vacuum packaging of foodstuffs
in order to extend their shelf life, for pickling or sous vide cooking.
Model: AVS0002 (Plug Type C), AVS0002-UK (Plug Type G).
Specifications
Voltage: 220 V; Frequency: 50 Hz. Power: 120.0 W. Capacity: up to 4.5 L/min.
Vacuum degree: –75 kPa. Vacuum sealing time: up to 20 sec. Single heat seal:
up to 13 sec. Heating wire width: 2 mm. Bag width sealable: up to 30 cm.
Maximum heating temperature: up to +200 °C. Modes: "Dry", "Moist". Control:
automatic, pulse (manual). Dimensions (L×W×H): 375×150×70 mm.
Scope of delivery (figure A)
Vacuum sealer AENO, vacuum bags (15×20 cm (5 pcs), 20×30 cm (5 pcs)),
adapter (vacuum hose) for vacuuming containers, quick start guide.
Limitations and Warnings
Please read this document carefully before using the unit. Before powering on
for the first time, make sure that the power supply corresponds to the
connection parameters of the device (frequency and voltage) from the
technical specifications section. Do not use the device if the power cord and/or
plug is damaged. The unit should be repaired by a qualified technician. Do not
immerse the device, power cord and/or plug in water or other liquids. Do not
install the unit on wet or hot surfaces or near external heat sources. To avoid
getting burned, do not touch the welding strip (9) and the weld after soldering
until they have cooled down. After each use of the vacuum sealer, especially if
plastic particles from the bag are left on the welding bar, it is necessary to clean
it. Unplug the unit by removing the power cord plug from the outlet and allow
to cool. Wipe the surface of the device with a soft cloth soaked in warm water
or a weak soap solution. Then wipe with a soft cloth soaked in clean water and
If you have any questions or difficulties with using your AENO device, please
contact support by e-mail at support@aeno.com or online chat at
aeno.com/service-and-warranty. The specialists will help you solve the
problem, and you will not have to waste time and effort visiting the store.
8
aeno.com/documents

Publicidad

loading

Productos relacionados para AENO VS2

Este manual también es adecuado para:

Vs2-ukAvs0002Avs0002-uk