Descargar Imprimir esta página

Kerbl TITAN B 480 Instrucciones De Servicio página 5

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 7
Operating Instructions
1
7
Ordinary operation with 9V dry battery,
or, optionally the device can be operated
8
with a 12V – wet accumulator!
Do not connect to operating equipment with
a mains connection.
a.) Installation
Assemble the earth electrode (7) as shown in the above figure; screw the earth connecting cable (8) onto the
earth electrode with the fastening screw. Drive the earth electrode into the ground as far as the angle brackets
and then place the appliance in upright position in the screwed-on angle brackets, see above figure.
b.) Functional description of the appliance
Open the appliance by pressing the catch hook on both sides and simultaneously raising the lid. Insert the
battery into the receptable and connect to the appliance. Close the lid. Operate the appliance only in vertical
position and with the catch hook clicked firmly into place. Put the appliance into service without fence and
earth. If the indicator light (5) flashes green, the appliance is ready for use. If it flashes red, check the 9V
battery for correct voltage (min. 6V). If the indicator light does not flash, check the battery for correct polarity or
have the appliance checked by a technician.
c.) Functional description with connected fence system ( fence + earth )
Indicator light (5): flashes green to indicate the fence condition or red to indicate the 9V battery condition
Flashes
Flashes
green
red
1
YES
NO
2
NO
NO
3
YES
YES
4
YES
NO
5
YES
NO
6
NO
NO
If the fence light flashes faster than approx. once per second, the appliance must be disconnected at once
and checked by a technician before it can be used again. The device provides 12v operation with total discharge
protection. This is indicated by red blinking of the pilot lamp. The 12V accumulator voltage should therefore be checked
at regular intervals with a highly accurate measuring instrument (see battery and accumulator maintenance in the
enclosed instruction manual). The appliance can also be operated with a solar kit obtainable through specialised dealers.
Any user of electric fence systems is legally indebted to control the fence-appliance and the fence system regularly, in
accordance with the conditions of use, at least once per day.
-
visual check of the appliance and the fence system
-
measurement of the minimum voltage of 2500V at each point of the fence
This equipment carries a 3-year warranty in accordance with our Warranty Terms & Conditions!
Please see the attached Operating Instructions for safety tips, earthing, commissioning, maintenance of battery
and accumulator, warranty terms and conditions and potential sources of fault!
SERVICE Addresses:
Please contact your specialist dealer
2
3
This energizer shall not be used as  
an animal trainer (inside a barn). 
Audible
Output voltage
clicks
YES
> 2500 V = minimum requirement
< 2500 see fault finding in enclosed instruction manual
YES
(Figure 2; p.5)
YES
> 2500 V = minimum requirement
YES
< 2500 V (Figure 2; S.5)
No pulses
NO
see b.) Functional description of the appliance, without fence and earth
NO
Rotary switch for power setting
4
1
0 = OFF; 1 = 35%; 2 = 55%; 3 = 70%;
5
4 = 80%; 5 = 100% capacity
6
2 Control lamp 9V battery
3 Control lamp fence
4 Earth connection
5 Fence connection
6 Closing buckles
7 Earth rod / holder
Earth connecting cable
8
(Connection between earth connection of
device and earth rod!)
3
-EN-
9V battery
OK (>6V)
OK (>6V)
Replace as soon
and:
as possible
Replace as soon
and:
as possible
Replace at once
Version : 2019.1

Publicidad

loading

Este manual también es adecuado para:

Ba-1271